THE USE OF A µCMM IN THE CALIBRATION OF HARDNESS INDENTERS
Abstract
In order to perform traceable hardness measurements using Rockwell Hardness Indenters, the indenter must conform to the requirement of ISO 6508-3 standard. The standard defines specifications for the geometric parameters for this type of indenter. Conformance to this standard is of particular importance to all calibration laboratories which operate in accordance with ISO/IEC 17025. At present there is no facility in South Africa with the capability of calibrating indenters for conformance to ISO 6508-3. This situation is being addressed through a series of studies currently being conducted at the National Metrology Institute of South Africa. The following parameters are calibrated using the µCMM. ISO 6508-3 specifies a radius of 200 µm with an uncertainty of ± 5 µm for Rockwell Hardness Indenter tips. Also specified in the ISO standard is the cone perpendicularity between the axis of the diamond cone to the axis of the indenter holder, with a specification of ± 0,03°. The last part of the ISO standard which was investigated states: “The surface of the cone and the spherical tip shall blend in a truly tangential manner.” All these parameters were measured and associated uncertainties calculated to prove conformance with ISO 6508-3 for the calibration of hardness indenters.
Event details
- Event
- Symposium on Recent Advancements in the Theory and Practice of Hardness Measurement
- Technical Committee
- TC5
- Place
- Tsukuba, JAPAN
- Time
- 19 November 2007 - 21 November 2007
- Website
- http://www.hardmeko2007.org