FAST TORQUE CALIBRATIONS USING CONTINUOUS PROCEDURES
Abstract
Unlike step procedures, continuous procedures permit calibrations to be carried out within a very short time. In continuous calibrations the fast change in torque and thus also in the signals give rise to specific problems. This paper gives advice on how to limit the influence of the most important effects on the measurement uncertainty. A simulation method is introduced, which allows the contribution of the reference creep to the measurement uncertainty to be calculated.
Event details
- Event
- Joint International Conference on Force, Mass, Torque, Hardness and Civil Engineering Metrology in the age of globalization
- Technical Committee
- TC3
- Place
- Celle, GERMANY
- Time
- 24 September 2002 - 26 September 2002