A COMPARISON OF PURELY STATIC AND CONTINUOUS TORQUE CALIBRATION PROCEDURE |
|---|
| S. Nattapon, S. Tassanai |
- Abstract:
- This paper presents the results of calibration procedure comparison in pure torque measurement with a synchronous system between the purely static (step-by-step) and continuous (quasi-static) facilities in order to prove the influence of the procedural conditions on the uncertainty of calibration. The filter setting (Low pass Bessel: 0.2 Hz, 1.25 Hz, 5 Hz and 10 Hz) and speed of applying torque (≈ 0.7 % of full scale/sec to ≈ 2.8% of full scale/sec) were varied to examine the effects of both parameters on the measurement results and to optimize the continuous procedure. The measurement was made by a torque calibration machine (TCM) with a reference torque transducer and the HBM MGCplus amplifier system using a comparison method.
The results of this experiment show the deviation between the purely static and continuous procedure within ± 0.01% of reading that was enough for class 0.2 torque measuring devices (DIN 51309) and torque transfer wrench (DAkkS-DKD-R 3-7) calibration. For the step-by-step measurement, the duration time in each torque step (form applying torque to data record) must be adequate for steady state of filter setting. For the continuous measurement, the speed of applying torque and filter setting should be optimized for best measurement capability. - Keywords:
- torque measurement, purely static and continuous facilities, synchronous system
- Download:
- IMEKO-TC3-2014-011.pdf
- DOI:
- -
- Event details
- IMEKO TC:
- TC3
- Event name:
- TC3 Conference 2014
- Title:
22nd Conference on the Measurement of Force, Mass and Torque (together with 3rd TC22 Conference on Vibration Measurement and 12th TC5 Conference on the Measurement of Hardness)
- Place:
- Cape Town, SOUTH AFRICA
- Time:
- 03 February 2014 - 06 February 2014